⚠️ High Alert Medication

Nitroglycerine (GTN) Infusion

Infusion pump continuous infusion preparation (200 mcg/mL), rapid hemodynamic titration, and hypotension surveillance protocol.

Infusion Pump Infusion Preparation (Standard Concentration)

Ampoule Presentation 5 mL ampoule (5 mg/mL of nitroglycerine)
Nitroglycerine Dose 50 mg (10 mL = two 5 mL ampoules)
Compatible Diluent D5W or 0.9% Sodium Chloride (NS)
Final Volume 250 mL
Final Concentration 200 mcg/mL (0.2 mg/mL)
Stability 24 hours at room temperature

Materials Required

  • Nitroglycerine ampoules 5 mg/mL (5 mL) × 2
  • 250 mL 0.9% Sodium Chloride (NS) or 5% Dextrose (D5W)
  • 10 mL sterile syringe
  • Sterile drawing-up needle / filter needle
  • Dedicated infusion pump label
  • Non-PVC (polyethylene-lined) extension line (100 cm)
  • Alcohol chlorhexidine swabs

Preparation Procedure (Aseptic Non-Touch Technique)

  1. Verification: Verify the written physician order, patient identity, clinical indication, and baseline blood pressure.
  2. PDE-5 Inhibitor Screen: Confirm the patient has not taken sildenafil or vardenafil in the past 24 hours, or tadalafil in the past 48 hours.
  3. Hand Hygiene: Perform thorough hand hygiene and clean preparation workspace.
  4. Ampoule Check: Check each nitroglycerine ampoule for:
    • Correct drug and strength, glyceryl trinitrate (5 mg/mL)
    • Expiry date
    • Container integrity, clarity, and absence of precipitate or discoloration
  5. Discard: Remove 10 mL from 250 mL of 0.9% Sodium Chloride or D5W(Volume in the bag 240 mL).
  6. Withdrawal: Open two ampoules of nitroglycerine. Withdraw 5 mL from each ampoule into a 10 mL syringe (Total nitroglycerine drawn: 10 mL = 50 mg nitroglycerine).
  7. Dilution: Add 10 mL of nitroglycerine to 240 mL of 0.9% Sodium Chloride or D5W to a final volume of 250 mL.
  8. Mixing: Gently invert the preparation several times to ensure uniform mixing.
  9. Visual Inspection: Inspect solution to ensure it is clear, colorless, and free of visible particles.
  10. Labeling & Dual Verification: Apply infusion label and obtain an independent double-check by another registered nurse.
  11. Infusion Pump Setup: Prime a non-PVC extension set and install into the infusion pump.

🔒 Tubing Policy: Standard PVC tubing absorbs a large and variable fraction of nitroglycerine, so the patient receives less than the programmed dose. Always use non-PVC (polyethylene) administration sets, and re-titrate carefully if the tubing type is changed.

⚠️ Line Access: Nitroglycerine may be infused via a peripheral or central line. Use a dedicated lumen so bolus flushes of other drugs do not deliver an unintended nitroglycerine bolus.

Dose-Dependent Hemodynamic Effects

Nitroglycerine releases nitric oxide in vascular smooth muscle. Venous capacitance vessels respond at low doses; arterioles need higher doses. Thresholds vary between patients, so titrate to clinical response.

Low Dose (Venodilation)

5–50 mcg/min
  • Venous pooling lowers preload, LVEDP, and pulmonary congestion
  • Reduces myocardial oxygen demand

Coronary Effect

Across the dose range
  • Dilates epicardial coronary arteries and collaterals
  • Relieves ischemic chest pain and coronary vasospasm

High Dose (Arteriolar Dilation)

> 100–150 mcg/min
  • Lowers systemic vascular resistance and afterload
  • Greater risk of hypotension and reflex tachycardia

Administration & Titration

Recommended Dosing Parameters

  • Administration Route: Administer via infusion pump through a non-PVC line; dedicated lumen preferred.
  • Recommended Starting Dose: 5 to 10 mcg/min.
  • Titration Step: Increase by 5 to 10 mcg/min every 3 to 5 minutes, according to target response and blood pressure.
  • Usual Maximum: 200 mcg/min. Higher doses only under direct intensivist supervision.
  • Tolerance: Tachyphylaxis may develop after 24 to 48 hours of continuous infusion; reassess the need and dose.
  • Weaning: Taper gradually to avoid rebound hypertension or ischemia.
  • Infusion Continuity: Do not allow the infusion to run out. An infusion can be made up to a maximum of 1 hour in advance and labelled clearly with contents and expiry.
  • Discard Policy: Discard 24 hours after preparation or earlier if the solution becomes discoloured, cloudy, or contaminated.

Hemodynamic Monitoring Requirements

  • Record blood pressure every 3 to 5 minutes during initiation and each titration step; continuous arterial monitoring preferred at higher doses.
  • Monitor heart rate and continuous ECG for reflex tachycardia and ischemic changes.
  • Reassess chest pain score, respiratory rate, oxygen saturation, and signs of pulmonary congestion.
  • With prolonged high-dose infusion, consider methemoglobin levels if cyanosis or unexplained hypoxemia develops.

Contraindications & Cautions

  • PDE-5 Inhibitors: Recent sildenafil, vardenafil, or tadalafil use; risk of severe, refractory hypotension.
  • Right Ventricular Infarction: Preload-dependent; nitrates can cause profound hypotension.
  • Hypovolemia: Uncorrected volume depletion.
  • Fixed Outflow Obstruction: Severe aortic stenosis or hypertrophic obstructive cardiomyopathy.
  • Raised Intracranial Pressure: Cerebral vasodilation may worsen ICP.

Hypotension Surveillance & Response Protocol

Nitroglycerine, principal acute hazard is sudden hypotension. Its short half-life means effects wear off within minutes of stopping the infusion.

Expected Response

  • Blood pressure within prescribed target
  • Improving chest pain or breathlessness
  • Heart rate stable
  • Patient alert and well perfused

Hypotension (SBP < 100 mmHg or Symptomatic):

  1. STOP or reduce infusion immediately.
  2. Position the patient supine with legs raised, unless pulmonary edema makes this unsafe.
  3. Notify clinician promptly.
  4. Recheck blood pressure every 2 to 3 minutes until stable.
  5. Document event in patient clinical record.

Nitroglycerine Infusion Rate Chart (200 mcg/mL)

Shows the infusion pump rate (mL/hr) for each dose, and the total volume infused over 24 hours (50 mg in 250 mL).

Dose
(mcg/min)
Pump Rate
(mL/hr)
Total Volume per 24 hr
(mL)
51.536
10372
154.5108
206144
309216
4012288
5015360
6018432
8024576
10030720
12036864
150451080
17552.51260
200601440

Infusion Conversion (Solution Concentration 200 mcg/mL)

Standard equations for a 200 mcg/mL solution (50 mg in 250 mL):

Infusion Rate (mL/hr):

Rate (mL/hr) = [ Dose (mcg/min) × 60 ] / 200

Shortcut: Rate = Dose × 0.3
Infusion Dose (micrograms/minute):

Dose (mcg/min) = [ Rate (mL/hour) × Concentration (200 mcg/mL) ] / 60

Shortcut: 1 mL/hr ≈ 3.33 mcg/min

'Shortcut' example: 20 mcg/min → 20 × 0.3 = 6 mL/hr.

© criticalcareinsights.com. All rights reserved. For clinical reference and educational use only.